Cleaning Hacks
Every hack is checked against a cited source · open the link to see where it comes from.
Never mix bleach with ammonia or vinegar
Combining bleach with ammonia or acids like vinegar makes toxic gas · use one product at a time.
Steps
- Use only one cleaning product at a time and never combine bleach with another cleaner.
- Keep bleach away from ammonia-based cleaners, vinegar, and other acids.
- Avoid applying heat to bleach solutions, which can also drive off gas.
- Ventilate the area and follow each product label's directions.
Why it works
Mixing bleach with vinegar or ammonia, or adding heat, generates chlorine and chloramine gases that can cause severe lung tissue damage when inhaled.
Good to know: Chlorine and chloramine gas can cause coughing, breathing trouble, and lung injury · never combine these products, even to 'clean faster'.
Source: U.S. Centers for Disease Control and Prevention (CDC)Clean with soap first, then disinfect
Wash dirt away before disinfecting and keep the surface wet for the full contact time so germs actually die.
- Soap + water
- Apply disinfect
- Stay wet
- Full contact time
Steps
- Clean the surface with soap and water first to remove dirt and grime.
- Apply the disinfectant and read the product label for its contact time.
- Keep the surface visibly wet for that entire contact time.
- Follow the label's directions for safe use and disposal.
Why it works
Dirt shields germs from disinfectant, so cleaning first lets the chemical reach them; the surface must stay wet for the full label contact time for the product to work.
Good to know: Always read and follow the disinfectant label for safe and effective use and disposal.
Source: U.S. Centers for Disease Control and Prevention (CDC)Steam-loosen baked-on microwave grime
Boil a cup of water inside to steam the walls, then wipe splatters off with almost no scrubbing.
- Caked splatter
- Wipes clean
Steps
- Put about 250 mL of water in a microwave-safe container in the center.
- Run the microwave (or its Steam Clean cycle) until the window steams up.
- Let it sit a few minutes so steam loosens the grime.
- Wipe the interior with a soft cloth or paper towel and mild detergent.
Why it works
Steam condenses on the interior and softens dried-on food splatters so they wipe away without abrasive scrubbing.
Good to know: The water and container will be hot · let it cool before removing.
Source: WhirlpoolWipe stainless steel with the grain
Wash with warm soapy water following the metal's grain lines, then dry · for streak-free, scratch-free shine.
- Across = streaks
- With grain = shine
Steps
- Wash with warm, soapy water and a nonabrasive sponge or soft cloth.
- Always rub evenly in the direction of the grain.
- Polish and dry with a clean microfiber or soft cloth so no water spots form.
- Make sure all surfaces are fully dry to avoid discoloration.
Why it works
Wiping along the grain follows the brushed finish so cleaning lines stay invisible, and drying prevents iron in water from leaving spots.
Good to know: Do not use steel wool, abrasive pads/powders, paper towels, ammonia, citrus-based, or vinegar-based cleaners · they can damage the finish.
Source: WhirlpoolSanitize cutting boards with a dilute bleach solution
Wash with hot soapy water, then flood with a weak bleach solution to kill germs left after cutting raw meat.
- Wash hot+soap
- 1 tbsp/gal bleach
- Stand minutes
- Rinse, air-dry
Steps
- After cutting raw meat, wash the board, knife, and counters with hot, soapy water.
- Mix 1 tablespoon of unscented, liquid chlorine bleach in 1 gallon of water.
- Flood the board surface with the solution and let it stand several minutes.
- Rinse with clean water and air-dry or pat dry with clean paper towels.
Why it works
Hot soapy water removes food and most bacteria, and the dilute chlorine bleach solution sanitizes the surface for extra protection against cross-contamination.
Good to know: Use unscented chlorine bleach only and never mix it with other cleaners · use separate boards for raw meat and for produce.
Source: USDA Food Safety and Inspection Service (FSIS)Deodorize the fridge with baking soda
Scrub the interior with a baking soda solution, then leave open baking soda or coffee grounds to absorb smells.
- Smelly fridge
- Fresh + clean
Steps
- Wash the interior, including the door and gasket, with hot water and baking soda.
- Rinse with a sanitizing solution and let it air out with the door open.
- For lingering odor, put fresh coffee grounds or baking soda loosely in an open, shallow container in the bottom.
- Repeat if a stubborn odor remains.
Source: USDA Food Safety and Inspection Service (FSIS)Why it works
Baking soda is a mild abrasive and odor absorber: scrubbing removes residue, and leaving it (or coffee grounds) open lets it keep soaking up smells over time.
Run a cleaning cycle on your washing machine
Drop a washer-cleaner tablet in the empty drum and run a hot cycle monthly to clear residue and odor.
- Empty drum
- Tablet in drum
- Hot clean cycle
Steps
- Remove any clothes from the empty washer drum.
- Place one washing machine cleaner tablet inside the drum (not the dispenser), with no detergent.
- Start the 'Clean Washer' cycle, or the hottest/largest cycle if there is no clean option.
- Let the cycle finish completely without opening the door.
Why it works
A hot cycle with a dedicated cleaner tablet dissolves detergent residue and buildup inside the drum that traps odor-causing bacteria.
Good to know: Do not add detergent and do not interrupt the cycle.
Source: WhirlpoolDescale a coffee maker with vinegar
Brew a half-vinegar, half-water solution to dissolve mineral scale, then rinse with two plain-water cycles.
- Half vinegar half water
- Brew cycle
- 2 water rinses
Steps
- Remove the water filter and empty the brew basket.
- Fill the carafe with half white vinegar and half water and pour it into the reservoir.
- Run a full brewing cycle with the vinegar solution; repeat if needed.
- Rinse by running two full brewing cycles with fresh, cool water.
Why it works
Acetic acid in vinegar dissolves the limescale (calcium and magnesium deposits) that builds up inside the water lines and slows brewing.
Good to know: Run the plain-water rinse cycles so no vinegar taste or residue is left behind.
Source: KitchenAidRinse the dishwasher filter and run a vinegar cycle
Rinse the bottom filter under warm water, then run a vinegar cycle to deep-clean a smelly dishwasher.
- Rinse filter
- 2 cups vinegar
- Full cycle
Steps
- Remove the filter from the bottom of the dishwasher and rinse it under warm water to clear food and grease.
- Reinstall the filter, then put 2 cups (500 mL) of white vinegar in a dishwasher-safe cup on the bottom rack.
- Run a complete cycle with an air-dry or energy-saving dry option and no detergent.
- Do this only occasionally, for a deep clean.
Why it works
The filter traps food debris that causes odor, and an occasional vinegar cycle dissolves grease and mineral film throughout the tub.
Good to know: Vinegar is an acid · using it too often could damage your dishwasher, so reserve it for deep cleans. Check your manual; some filters are not removable.
Source: WhirlpoolToss fridge perishables after 4 hours without power
After an outage, keep the door shut · food stays safe ~4 hours, then discard perishables you cannot keep cold.
Steps
- During an outage, keep the refrigerator door closed to hold the cold in.
- A closed fridge keeps food safe for up to about 4 hours.
- After 4 hours without power or a cold source like ice, throw out perishables (meat, fish, cut produce, eggs, milk, leftovers).
- When in doubt, throw it out · do not taste-test.
Why it works
Above 40F, bacteria on perishable foods multiply quickly, so a closed fridge only buys about four hours before those foods become unsafe.
Good to know: Never taste food to check if it is safe · discard perishables held above 40F for over 4 hours even if they look and smell fine.
Source: U.S. Centers for Disease Control and Prevention (CDC)